How To Reset Samsung Dryer Hc Error Code

First, Unplug The Dryer For Five Minutes To Reset The Control Board.

Run the dryer again after 1 minute. When to reset (and when not to) resetting your dryer will clear out all the err Reconnect any loose wires or replace the wire harness if.

Reconnect The Wire Harness If Loose Or Disconnected.

Samsung dryer error codes fc, fe, and 1 fc (frequency errors) samsung dryer error codes fc, fe, and 1 fc codes mean that there is an invalid power source frequency. • if this information code remains, contact a samsung service center. This ‘error is too technical’ for the machine to explain and for you to understand.

Then Plug The Dryer Back.

To reset the error, can you press and hold wrinkle prevent, dry level and time buttons together for around 5 seconds. Next, unplug the dryer and check the wiring connections on the heating element. To fix this, try restarting the cycle.

David Here With You Bringing You Another Video!

Unplug it (or turn off power at the circuit breaker), wait some time for the electrical charge to clear out of the dryer (usually 1 to 5 minutes at most), and then power it up again. Shut off the dryer for 60 seconds, and then turn it back on again. To troubleshoot the problem you could either clean the lint system or the vent or better yet, you could clean both of them.

How Long Has This Been Going On With Your Samsung Dryer?

Take out the lint trap and remove any large dust particles. You will hear 3 beeping sounds. Press and hold the timed button and the mixed load bell button for several seconds and this will run a smart check on the dryer and it should clear any error codes stored in there.